There’s no doubt that creating projects using epoxy resin creates a beautiful high gloss finish. Crafters and wood project enthusiast choose to use epoxy resin because of its ability to add shine and protection to wood projects. The truth is not all epoxy resin is created equal. Continue reading to learn more about epoxy resin for wood.
Common Projects Epoxy Resin Is Added To
It is common for the clear epoxy resin to be applied over tabletops and countertops. Before applying epoxy resin your project should be pre-sanded and pre-finished. A smoother surface will limit the number of bubbles that will form over the wooden surface. Epoxy resin can be quite expensive so be sure you know how to apply epoxy resin to ensure you don’t waste your money.
The average price for 1 gallon of clear epoxy resin is $70. You get two formulas. One is the clear epoxy resin and the other is the hardener that you have to mix with the clear epoxy. Your aim is to get a 50/50 mixture per volume of solution. Before opening either solution be sure to wear protective gloves and eye-protective gear if this is your first time.
Prepare Your Surface
While working with resin ensure that your area and environment is free from dust and debris. You can prep your working space by using a fan and placing a filter behind the running fan. You may also consider using a tack cloth to wipe down your wooded surface after spraying surface cleaner over it. The filter will catch debris as the fan is running. This part is one of the most important parts before applying resin.
You get roughly 30 minutes before your epoxy resin starts to set. So as a good rule of thumb it is advised to mix for about 3 to 5 min and then apply the epoxy resin. What professionals do is they mix a small amount and apply the resin to cracks on the wood surface before applying the final finish.
This helps to fill air holes. By applying another very thin layer over the entire wooden surface the entire surface should be free of air bubbles when the final coat is applied. It is common to use a foam brush for this task. Using a heat gun you are apple to heat the resin on the wooden surface and pop the visible air bubbles if any exist.
Waiting Time Before Flood Coat
Before doing the flood coat it is best to wait a total of 48 hours. This will guarantee the thin coat is completely dry. The thin coat needs to be roughed up again with 320 sandpaper. This will make the flood coat stick better to the thin coat. Using acetone you are able to wipe down your wood project.
While wiping be sure to listen for a squeak. The squeak will signify you have a clean surface ready for its next step. It’s also recommended that you know how to mix epoxy resin according to weight. That way you don’t waste epoxy resin after your flood coat has been poured.
To catch the drips that will occur lay down some freezer paper with the glossy side up. Instead of using a foam brush this time you will use a scraper. Using the scrapper you will level the epoxy to get an even coat. The last step is to take a torch and lightly pop the air bubbles. Epoxy resin does self-level on its own. So once you have done your part allow the resin time to do its part. These are available on Eyecandycustomzus website and one can easily find epoxy resin as well as a variety of color pigments to buy from… also to learn more about the benefits of color pigmentations used for epoxy resin you can see the product descriptions available to each product on the site.